Installing The Charging Station - Moneual RYDIS Hybrid H68 Pro User Manual

RYDIS H68 Pro

Installing the Charging Station

1
Connect the power adaptor.
Set the RYDIS H68 Pro detection distance
[16ft (5m) or 26ft (8m)].
Place the power adaptor inside of the
charging station.
2
Check the power connection and make sure blue lamp is on.
3
Make sure the location of the charging station is an open
area as illustrated.
Clear all obstacles in the area within 5ft (1.5m) in front,
left, and right of the charging station
Install the charging station firmly against the wall.
If you install the RYDIS H68 Pro in a place where it will be exposed to direct sunlight, the heat of the
sun may interfere with the auto charging, and the RYDIS H68 Pro may become discolored over time.
If you install the charging station near a rug or threshold area, the RYDIS H68 Pro may not be able to return
to the charging station.
If your RYDIS H68 Pro can't return to the charging station, reset the detection distance as recommended below.
In a narrow area, set it to16ft (5m), and in a wide area, set it to 26ft (8m).
If you set the detection distance to 26ft (8m) in a narrow area, the Auto Charging may be interfered with.
16
5ft
(1.5m)
5ft
5ft
(1.5m)
(1.5m)