Troubleshooting - Moneual RYDIS Hybrid H68 Pro User Manual

RYDIS H68 Pro

Troubleshooting

Problem
If the RYDIS H68 Pro does not work or
if the power is not turning on.
If the RYDIS H68 Pro does not charge.
If the RYDIS H68 Pro does not return
to the charging station.
If the remote control does not work.
If the suction power is weaker than
normal.
If the main brush does not rotate.
If the side brushes do not rotate.
If the operational noise is louder than
normal.
52
Turn on the system power switch at the lower-rear side of the RYDIS H68 Pro.
Check the battery level lamp on the control panel.
Charge the battery if the battery level is low.
Clean the charging terminals on the bottom of the RYDIS H68 Pro and the
charging station.
Check if the charging lamp is lit up blue for power on and red for charging.
If not, then check if the power cord is connected to the charging station.
Turn on the system power switch at the rear of the RYDIS H68 Pro.
You can also charge the RYDIS H68 Pro by connecting the power adaptor
directly to the power jack at the rear side of the robot vacuum cleaner.
Check the power connection and make sure blue lamp is on.
Make sure the charging station is installed to the wall solidly.
Make sure the location of the charging station is an open area.
See page 16 for Installing the Charging Station.
Clear all obstacles around the charging station.
Install the charging station on hard floor when mop is attached.
Turn on the system power switch at the rear side of the RYDIS H68 Pro.
Replace the batteries on the remote control.
Empty the dust bin.
Clean the filter of the dust bin.
Check if there is anything blocking the dust inlet.
Check if the Turbo option is on. If the Turbo option is on, it will provide more
suction power.
Check if there is anything tangled in the main brush.
Make sure the main brush has been installed properly.
Check if there is anything tangled in the side brushes.
Make sure the side brushes have been installed properly.
Check if there is anything tangled in the main brush.
Make sure the main brush has been installed properly.
If the Turbo option is on, that can generate more noise.
Solution