Table of Contents
Advertisement
5.5.9 Electrically height-adjust-
able legrests
See the 'Operating Manual for Control
Units' for information on how to adjust
the electrically height-adjustable legrests.
5.5.9.1 Detaching the legrests
Pull up the locking device (Fig. 54/
swivel out the legrest and then pull it off
in an upward direction.
5.5.9.2 Hanging in the legrests
With the legrest in a swivelled-aside
position, hang it in and then swivel it to
the front until the locking device audi-
bly latches. – Check that it is secure!
5.5.9.3 Adjusting the height of
the foot plate
Hold the foot plate and then unscrew
the clamping screw (Fig. 55/
about ½ a turn.
Move the foot plate to the desired height
and then tighten the clamping screw.
40
1
),
54
55
Attention:
) by
The marking (hole) shows the max-
!
imum extension.
5.5.9.4 Positioning the calf plate
The calf plate can be fixed at one of
three different depth positions after the
securing screw (Fig. 55/
removed.
6. Options
Options are not a part of the standard
scope of supply.
Note:
Options from other companies can
cause malfunctions.
6.1 Seatbelt
The wheelchair can be equipped with a
seatbelt if necessary. The purpose of the
3
safety belt is to strap in the wheelchair
user. As an additional stabilisation of the
sitting position, it prevents the user from
falling forwards out of the wheelchair
(depending on the degree of the disa-
2
bility) and can be infinitely adjusted to
suit the user.
The retrofitting must be carried out by
an authorised workshop.
Attention:
The seatbelt is not a part of the se-
!
curing system for the wheelchair, or
the person sitting in the wheelchair,
during the transport in a disabled
person transport vehicle.
– Do not jam any items under the belt
) has been
strap.
56
The seatbelt is screwed on, from the
outer side, at the respective backrest
holder. The assembly is carried out as
shown (Fig. 56).
The armrest can be detached in an up-
ward direction for an easier attaching
of the seatbelt.
6.1.1 Putting on the seatbelt
with Velcro fastener
Pull both seatbelt straps to the front and
close the Velcro fastener.
Attention:
Make sure that there are no objects
!
trapped under the seatbelt! – Thus
you avoid painful pressure points.
41
Hide quick links:
Advertisement
Table of Contents
