Table of Contents
Advertisement
3.2.2 30°-mechanically-adjust-
able backrest
The backrest angle can be mechanically
adjusted by up to 30° (fig. 10). Both
clamping levers (fig. 11/
) must be
slackened to adjust the angle.
Note:
Set both rear tubes to the same posi-
tion when the seat is occupied.
Clean clamping surfaces (fig. 12)
ensure a permanent functioning.
Attention:
!
Adjusting the angle increases the
danger of tipping over and should
only be undertaken if stabilisers are
fitted!
18
10
1
1
11
12
3.2.3 Height-adjustable sliding
handles
The height of the sliding handles (fig.
13) can be variably adjusted. The han-
dles can also be secured against twist-
ing and pulling out of position
For variable height adjustment, loosen
the locking screw (fig. 14/
). And re-
tighten when adjustment is complete.
3.2.4 Back stiffening bar
Before folding the wheelchair, the slid-
ing sleeve for locking the back stiffen-
ing bar should be pushed outwards to
the right (fig. 15/
).
The halves of the stiffening bar are swiv-
elled down for the folding (fig. 16).
13
1
14
1
15
16
19
Advertisement
Table of Contents
