Table of Contents
Advertisement
5.2.2 Standard backrest
Tool:
1 x 13 mm open-end or ring spanner
1x hexagonal stud wrench WW 6
The angle of the standard backrest (Fig.
31/
) can be infinitely adjusted be-
tween approx. 0° to 5° with the adjust-
ment screw and the lock nut.
5.2.2.1 Folding down the back-
rest
Screw far out the clamping screw (Fig.
31/
) at both sides. Pull up the back-
rest and then fold it forwards.
5.2.2.2 Folding upright the back-
rest
Bring the backrest into the upright posi-
tion, then press it fully down and tight-
en the clamping screws (Fig. 31/
30
31
).
5.2.3 30° backrest
The angle of the 30° backrest (Fig. 59)
can be infinitely-adjusted between ap-
prox. -5° and 30°.
The adjustable backrest is combined with
the sloped armrest (Fig. 33/ ) to pre-
vent a trapping between the backrest
and armrest.
5.2.3.1 Adjusting the backrest
angle
You unlock the backrest by simultane-
ously pulling both levers (Fig. 34/
the push bar. Then move the backrest
to the desired angle (Fig. 34/
) and
release both levers. The backrest is then
locked in this position.
Attention:
Only incline the backrest to the rear
!
when the wheelchair is standing on
a level surface. Danger of tipping
over when the backrest is inclined to
the rear.
1
33
) on
34
31
Hide quick links:
Advertisement
Table of Contents
