Table of Contents
Advertisement
4.6 Seat depth
Attention:
An adjustment of the seat depth
!
should be done in an authorised spe-
cialist workshop!
4.6.1 Adjustment of the seat
depth
The seat depth can be adjusted by re-
positioning the back tubes from 43 cm
in steps of 2 cm to 51 cm.
Disassemble the attachment screws (fig.
23/
). After repositioning the back
tubes to the desired seat depth, retight-
en the attachment screws.
4.7 Angle adjustable
backrest (gas
spring adjustment)
For variable adjustment up to 30° (fig.
24) pull the release levers (fig. 25/
Attention:
Adjusting the angle increases the
!
danger of tipping over and should
only be undertaken if stabilisers are
fitted!
22
1
23
24
).
1
25
4.8 Height-adjustable
sliding handles
The height of the sliding handles can
be variably adjusted. The handles can
also be secured against twisting and
pulling out of position.
For variable height adjustment, loosen
the locking screw (fig. 26/
). Tighten
the clamping screw after the adjustment.
4.9 Headrest
The headrest (fig. 27) can be adjusted
to suit the respective user.
Slacken the locking screw (fig. 27/
to adjust the height.
Slacken the locking screws (fig. 27/
to position the headrest.
For angle adjustment loosen the clamp-
ing screws 27/
.
Remark:
When adjustment is complete, re-
tighten the clamping device screws.
1
26
3
2
)
1
)
27
23
Advertisement
Table of Contents
