Table of Contents
Advertisement
6.1.2 Putting on the seatbelt
with catch
Pull both seat straps to the front and push
the latch tongue deep into the catch
(Fig. 57) until the automatic latching
mechanism audibly latches. Then carry
out a pull test.
Attention:
Make sure that there are no objects
!
trapped under the seatbelt! – Thus
you avoid painful pressure points.
6.1.3 Opening the seatbelt
Unfasten the safety belt by pressing the
red release key on the latch mechanism
(see Fig. 57).
6.1.4 Adjusting the belt length
To lengthen or shorten the seat strap,
pull it at a right angle to the catch in
the corresponding direction. The excess
strap length is retained by displacing the
plastic slider.
Note:
The safety belt should be a tight but
not too taut.
42
57
6.2 Headrest
The headrest in combination with the
Ergorpor backrest element (Fig. 58) is
non-twisting, height-adjustable and de-
tachable.
Attention:
We recommend the fitting of two
!
rear-view mirrors for driving with a
headrest.
6.2.1 Adjusting the headrest
The headrest can be detached or ad-
justed in height after the clamping
screw (Fig. 59/
) has been slackened.
Slacken the clamping screw (Fig. 60/
and position the headrest at the desired
height. Tighten the clamping screw (Fig.
60/
).
Attention:
The maximum height adjustment is
!
indicated by the marking.
58
)
59
2
60
1
43
Hide quick links:
Advertisement
Table of Contents
