Table of Contents
Advertisement
Chapter 3 Hardware Installation and
3.1 Jumpers and Connectors
The ARK-3382 Embedded Box Computer consists of a PC-based com-
puter that is housed in an aluminum top cover, a metal bottom case with
accessible bottom cover and Front/ Rear Metal Face plate. Your HDD,
SDRAM, are all readily accessible by removing the bottom cover. Any
maintenance or hardware upgrades can be easily completed after remov-
ing the top cover, and Front with Rear Metal Face plate. If you are a sys-
tems integrator and need to know how to completely disassemble the
embedded box computer, you can find more useful information in Chap-
ter 6.
Warning!
3.2 Setting jumpers
You can configure your ARK-3382 to match the needs of your applica-
tion by setting jumpers. A jumper is the simplest kind of electrical switch.
It consists of two metal pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect them. To "close" a
jumper, you connect the pins with the clip. To "open" a jumper you
remove the clip. Sometimes a jumper will have three pins, labeled 1, 2,
and 3. In this case, you would connect either pins 1 and 2 or pins 2 and 3.
ARK-3382 User Manual
Upgrade
Do not remove any mechanical parts, such as
the top cover, bottom cover and front with rear
face plate until you have verified that no power is
flowing within the Embedded Box Computer.
Power must be switched off and the power cord
must be unplugged. Every time you service the
Embedded Box Computer, you should be aware
of this.
20
Advertisement
Table of Contents
