Advertisement
Step 7
Power ON the PC and display or connected RS-232 devices. Ensure
"DVI/HDMI" and "LINK" indication LEDs lit ON, representing secure
connection of all kinds of cables. Confirm LED of the selected audio input lit
ON.
Tip 1: If any status LED is not ON normally after all installation as guided in
the above, we recommend you to push "RESET" button while all connections
are set and the Uplink and Downlink modules are powered in. "Reset"
function is designed for HPD(Hot Plug Detection) check.
Tip 2: Avoid "hot plugging" the Uplink as this is not recommended practice
with live digital voltages.
1-6 Installation
Booster and EQ Mode Setting
Booster and EQ Mode is used extensions over 10 m (33 feet). By default, M5-
2C2 transmitter and receiver are set to "BOOSTER" and "AUTO" respectively.
Under the default setting, M5-2C2 is optimized for the length from 10m
(33feet) to 40m (130feet). If you don't get a picture still or have noise, Booster
and EQ Mode Setting are required like the followings.
1. Start by having the source equipments connected by cables and
playing with your display on.
2. Set the transmitter to "BOOSTER" by "BOOSTER" switch on the front
side of Uplink module. Check if the display is displayed normally.
3. If you don't get a picture still or have noise, set the receiver to
"MANUAL" using "EQ MODE" switch of Downlink module.
4. Start with the "EQUALIZER" knob all the way counter clockwise and
slowly turn the knob clockwise until the display is shown normally.
Table - Recommended Setting with the Length
Tx – Booster
Rx – EQ Mode
Normal
Booster
Booster
1-7 Booster and EQ Mode Setting
Acceptable Length
Auto
1~10m
Auto
10~40m
Manual
40~50m
Advertisement
