Table of Contents
Advertisement
Modules: MADI Sub-Menu
MADI 1 port is included as standard with each Horus. MADI 2 will be listed as "EMPTY" in Horus units
which are not fitted with the optional MADI expansion card
Mode:
Physical Mode:
High Speed Frame:
Input:
Output Sources:
Sets the MADI mode to either "Standard" (56 audio channels) or "Extended"
(64 channels). To determine which setting(s) you are able to use, please
consult the user manual of the device you are connecting the Horus to in order
to see which (if not both) formats it complies with.
Choose the input signal to be derived from the Coaxial or Optical MADI
connections at the back of the Horus unit. You can choose to use either or, but
not both at the same time. On the Output side, however, both Coaxial and
Optical outputs are always driven in parallel.
Choose between using Legacy or High-speed frames. For information on why
you might want to set this to something other than the default (High-Speed)
please consult the user manual of the device you are connecting Horus to.
Enabling Visible to Ravenna will allow Ravenna to "see" and use the I/O
Connections (seen in the Auto-Connect utility). Use the Auto-Connect utility to
activate the I/O stream connections.
Users can route literally any input signal to any output module. Users can also
route any input signal to any combination of output modules. Signals are
routable in blocks of 8 channels.
The example picture below shows a MADI output routing
Module AES 1:
Routed to MADI channels
Module AES 2:
Routed to MADI channels
Module AES 3:
Routed to MADI channels
Module A/D 1:
Routed to MADI channels
www.merging.com/horus
Horus User Manual
1 to 8
9 to 16
17 to 24
25 to 32
Page 42
Advertisement
Table of Contents
