Merging HORUS-AD8 User Manual page 19

Horus User Manual
Connecting the AES-EBU cable
The AES ports connect the AES-EBU I/O using DB25 D-SUB connections.
Please ensure that the cables you have chosen to use, or have had made, conform to this specification
before you attempt to connect them.
To connect the DSUB connection to the AES port, align the Male connector with the female DSUB port
on the module. Then, with slight pressure, guide the connector into place. If your DSUB connector has
mounting screws on either side, then fasten them finger-tightn once the cable has been pushed into
place.
Note: The pinout of the DB-25 is as per Tascam Digital.
* THESE CONNECTIONS ARE NOT MEANT TO SUPPORT ANY SIGNIFICANT WEIGHT.*
Ensure that there is no strain from the connected cable as any significant pressure to the module's DSUB
connector could damage the Horus unit.
www.merging.com/horus Page 19