HP J3178A Hardware Installation Manual page 102

File Transfers
Transferring Switch Configurations
3.
C-10
At the command prompt, execute one of the following commands:
To upload a configuration to a file on a PC or Unix workstation:
zput config remote_file [overwrite] [dos/unix]
To download a configuration from a file on a PC or Unix workstation:
zget config remote_file [dos/unix]
where: remote_file is the name of the file in which the configuration
is stored
[overwrite] is one of the following optional values:
(the default) allows a new file to be created, but
0
does not allow an existing file to be overwritten.
creates a new file or overwrites an existing file.
1
[dos/unix] is one of the following optional values:
(the default) specifies the DOS file format.
0
specifies the Unix file format.
1
If the PC or workstation does not respond to a ZPut or ZGet command
within approximately 70 seconds, the command times out and control
returns to the prompt line.