Table of Contents
Advertisement
Programming
The reader is factory-configured with a set of standard default fea-
tures. After scanning the interface barcode from the Interfaces sec-
tion, you can select other options and customize your reader
through use of the instructions and programming barcodes avail-
able in the Gryphon™ I GD4100/GM410X Product Reference
Guide (PRG). Check the corresponding features section for your
interface, and also the Data Editing and Symbologies chapters of
the PRG.
Using the Programming Barcodes
This manual contains barcodes which allow you to reconfigure
your reader. Some programming barcode labels, like the Standard
Product Default Settings on page 31, require only the scan of that
single label to enact the change.
Other barcodes require the reader to be placed in Programming
Mode prior to scanning them. Scan an ENTER/EXIT barcode
once to enter Programming Mode, scan the desired parameter set-
tings, then scan the ENTER/EXIT barcode a second time to ac-
cept your changes, exit Programming Mode and return the reader
to normal operation.
Configure Other Settings
Additional programming barcodes are available in the Gry-
phon™ I GD4100/GM410X PRG to allow for customizing pro-
gramming features. If your installation requires different
programming than the standard factory default settings, refer to
the PRG.
Resetting Standard Product Defaults
If you aren't sure what programming options are in your reader,
or you've changed some options and want the factory settings re-
stored, scan the Standard Product Default Settings barcode below
to copy the factory configuration for the currently active interface
to the current configuration.
Quick Reference Guide
Factory defaults are based on the interface type. Con-
figure the reader for the correct interface before scan-
ning this label.
Standard Product Default Settings
Programming
31
Advertisement
Table of Contents
