Table of Contents
Advertisement
Playing Audio CDs
Loading and Playing an Audio CD
Before you load a disc, make sure that it is compatible with the player. Note that the following
discs CANNOT be used with this player:
•
Laserdisc
•
CD-I, CD-ROM, CD-R, DVD-ROM
•
MiniDisc
•
CD-G discs play audio only, not graphics
To Load and Play an Audio CD
Insert with the label
facing up.
Audio CD Playback Features
When playing audio CDs, your DVD player has many of the same features that your CD player
has, including track skip, repeat play, and programmed playback.
Selecting a Specific Track
The current track number and elapsed playback time for that track are displayed on the front of
the player. You can also see this information by accessing the info banner (by pressing INFO on
the remote).
Use the number buttons on the remote to enter the desired track number. You must enter a 2-digit
number. For tracks 1–9 of a CD, press 0 and then the track number.
Track Skip
Because program content on an audio CD can be divided into tracks, you can skip through a
disc's contents one track at a time.
•
Press and release the CH – button on the remote to go to the beginning of the chapter that is
playing. Press again to go to the beginning of the preceding chapter. When the remote is in
TV mode, this button changes the TV to the previous channel (if the remote has been
programmed to operate the TV).
•
Press and release the CH + button on the remote to go to the beginning of the next chapter.
When the remote is in TV mode, this button changes the TV to the next channel (if the remote
has been programmed to operate the TV).
38
1. Press the OPEN•CLOSE button on the front of the DVD player.
2. Place a disc gently into the tray with the disc's label facing up.
3. Press OPEN•CLOSE or PLAY to close the disc tray.
The DVD player reads the disc's table of contents, and then begins disc playback.
4. Press STOP to stop playback.
chapter 3
Advertisement
Table of Contents
Troubleshooting
