The Remote Control; Component Buttons - RCA RC6000P User Manual

Connections and Setup

The Remote Control

You can use this remote to control compatible televisions and A/V receiver/amplifiers. The TV
button is programmed to operate most PROSCAN, RCA, and GE televisions. The remote can also
operate other brands of televisions, but you must manually program it to do so (see chapter 6).

Component Buttons

Pick the Right Mode
The remote control packed with your player is able to operate the DVD player and the television,
but you have to tell the remote which component you want it to operate. If the remote is
operating the TV, it's in TV mode. If it's operating the DVD player, it's in DVD mode. Make sure
you press the component button on the remote that matches the component you want the remote
to operate.
In order for the remote control to operate a television or this DVD player, you must press the
appropriate button to put the remote in the correct mode.
ON OFF
DVD
AUX ZOOM RANDOM
MUTE
REPEAT
GUIDE
OK
MENU
1 2
4 5
7 8
INPUT
0
REVERSE PLAY
MARKER
STOP
SUBTITLE AUDIO ANGLE
The component buttons (TV and DVD) are at the top
of the remote control, near the ON•OFF button.
20
TV
3
-D
PLAY MODE
GO BACK
INFO
CLEAR
3
6
9
ANTENNA
FORWARD
PAUSE
OPEN•CLOSE
AUX Press this button to turn on a component you've programmed to
work with the remote (see chapter 6 for more information on
programming the remote) and to set the remote to control that
component.
DVD Sets the remote to control the DVD player.
TV Press this button to turn on most RCA, GE, or PROSCAN TVs and
set the remote to control the TV. Used with ON•OFF button to
turn on some other brands of TVs.
Note: If you would like to operate more components from a single
remote control, you can do so with a universal remote control.
See chapter 6 for ordering information.
Point the Remote in the Right Direction
It's important to point the remote at the component you want to operate.
When you want the remote to operate the DVD Player, point the remote
at the DVD Player; not at the TV. The remote has to be pointed in the
correct direction and toward the correct component in order for the
remote control's signal to communicate with the sensor on the
component. Make sure there is a clear path between the remote
and the component you want to operate.
control
chapter 1