Configuration Information - Factory Integrated Models - HP Integrity BL870c Quickspecs

QuickSpecs

Configuration Information - Factory Integrated Models

NOTE: This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid
configurations are ordered, HP recommends the use of an HP approved configurator. Contact your local sales
representative for information on CTO product offerings and requirements.
NOTE: This product offering does not support HP Factory Express Server Configuration Level 1.
NOTE: HP does not allow factory integration of options into standard models listed above.
Configure-to-order servers must start with a CTO Enclosure
NOTE: FIO indicates that this option is a Factory Installable Option.
Step 1: Base Server Blade Configuration
Base Unit
Step 2: Choose Required Options (one of the following from each list unless
otherwise noted):
Processors
(Select minimum one (1)
and maximum four (4)
processors)
Memory
(Select minimum one (1)
and maximum six (6)
memory modules)
HP c-Class Enclosures
(Select minimum one (1)
enclosures)
HP Integrity BL870c Server Blade
NOTE: Choose the base models.
NOTE: Adding Option code "#0D1" to the Server Blade P/N will integrate the
configured blade into the enclosure (which must be on the same order)
Base unit standard features:
Four embedded Gigabit Ethernet NIC ports plus (1) additional 10/100 NIC
dedicated to Integrity iLO 2 Management
Integrated LSI 1068 hardware RAID controller
Four small form factor (SFF) SAS hot plug hard drive bays
HP Integrity Integrated Lights-Out 2 Advanced Pack
Support for up to 96GB memory with support for 24 DIMM slots
Support for up to three c-Class mezzanine cards
Intel® Itanium® Dual-Core Processors Model 9150N (1.6 GHz, 24MB, 533FSB,
L3 cache)
Intel® Itanium® Dual-Core Processors Model 9140N (1.6 GHz, 18MB, 533FSB,
L3 cache)
Intel® Itanium ® Dual-Core Processors Model 9120N (1.42 GHz, 12MB.
533FSB, L3 cache)
4GB PC2-4200 DDR2-5300 Quad Memory
8GB PC2-4200 DDR2-5300 Quad Memory
16GB PC2-4200 DDR2-5300 Quad Memory
NOTE: Memory Modules consist of four individual DIMMs
NOTE: DIMMs must be installed in quads
c7000 BCS c-Class Enclosure, FIO
c3000 BCS c-Class Enclosure, FIO
DA - 12926 Worldwide QuickSpecs — Version 1 — 2.11.2008
HP Integrity BL870c Server Blade
AH232A
AH320A
AH255A
AH256A
AH252A
AH253A
AH254A
AD361B
AH257A
Page 19