Bi-D. Adjustment; Eeprom Initialization Method; Initialization - Epson LQ-570e Service Manual

EPSON LQ-570e/LQ-580
Table 1-32. Setting Menu
Item
Font *1 OCR-B, Orator, Orator-S, Script C, Roman T, Sans serif H
Manual feed wait time 1 second, 1.5 seconds, 2 seconds, 3 seconds
Buzzer OFF, ON
Auto CR (IBM 2390 Plus) OFF, ON
A.G.M. (IBM 2390 Plus) OFF, ON
Roll Paper OFF, ON
*1: One of these fonts in the default setting is corresponding to others (= other fonts) on the
control panel.
Following fonts are not selected in the default setting mode.
Draft, Roman, Sans serif, Courier, Prestige and Script
*2: Setting with underline mean the standard factory settings.

1.5.3 Bi-d. Adjustment

Bi-d. adjustment can be adjusted by users. Refer to 5.2.4 "Bi-D Adjustment" for Bi-d.
adjustment method.

1.5.4 EEPROM Initialization Method

Reboot with P AUSE SW + LOAD/EJECT SW + LF/FF SW pressed, EEPROM is
¨ ¨ ¨
initialized.
Reboot with T EAR OFF/BIN SW + LOAD/EJECT SW pressed, the memory area of
¨ ¨ ¨
the accumulative printed columns for ribbon replacement is cleared.
Product Description
Setting / Value *2
Operation

1.5.5 Initialization

o Power-on initialization
The initialization of this level is activated by power-on or cold-reset command
(remote RS command).
This initialization is;
n to initialize the printer mechanism.
n to execute Operator initialization.
o Operator initialization
The initialization of this level is activated by -INT signal (negative pulse).
This initialization is;
n to clear the all buffers of data.
n to cancel the printer stand-by state, if no errors occur.
n to execute Software initialization.
o Software initialization
The initialization of this level is activated by the control code ESC@.
This initialization is;
n to clear the unprinted data.
n to make the printer's setting defaults.
o Initialization by control panel operation
The printer is initialized by pressing Font switch and Condensed switch at the
same time.
This initialization is;
n to clear the all buffers of data.
n to clear the unprinted data.
n to make the printer's setting defaults.
Revision C
36