Factory Setting - Epson LQ-570e Service Manual

EPSON LQ-570e/LQ-580

5.2.3 Factory Setting

The factory settings of the printer for each destination are installed in the EEPROM on the
main board. Therefore, If you have replaced the main board, you must re-install them again
by the adjustment program. This section describes how to install the factory settings:
1. Connect the printer and the host DOS/V computer with a parallel interface cable.
2. Set the 10 inch width continuous paper to the printer.
3. Run the adjustment program in the host computer.
Program Name: Q80A10V
* Run "Autoexec.bat" file from attached 3.5 inch program FD.
4. Operating System selet menu appears. Type "G" to run GWbasic.
5. Printer Name inputting menu appears. Input "LQ-570e or LQ-580".
6. The printhead wire select menu appears. Move the cursor using "
select "24 pin" from the list and press "Enter" key.
Adjustment
7. Then the market setting menu appears. Referring to the market list table, move the
cursor using "
To change the choice to the other market after selection, you may press "ESC" key
only. The market setting menu appears again. An example (for EUR) is shown below:
Destination
EAL, ESP, EHK,
EHK(PHIL)
EURO, EDG, EUL,
↑ ↓
" or " " key to
EUL (230V, 240V), EFS,
EIS, EIB
EAI, EAI (Latin)
EMO
Adjustment and Resetting the Printer
↑ ↓
" or " " key to select your market from the list and press "Enter" key.
Table 5-3. Market List
Code Destination
USASTD EDG (NLSP), EUL (NLSP),
EIS (NLSP)
EURSTD EUL (120V)
USASTD2 EKL
RUSSIAN
Revision C
Code
NLSP
DEFSTD
KOREAN
97