Epson LQ-570e Service Manual page 90

EPSON LQ-570e/LQ-580
When attaching the timing belt to the carriage assembly, secure the
timing belt using the left and light clips of the carriage assembly as
shown below.
C l i p
T I M I N G B E L T
Figure 4-25. Attaching the Timing Belt
When mounting the carriage assembly and guide CR shaft;
n Check the direction of the guide CR shaft during insertion.
n Check the CR assembly smoothly slide down when the shaft is
put vertical.
n Check the big hole of the guide CR shaft faces up.
n Insert the tab of the CR assembly into the cutout section and
slide CR assembly to the left side of the mechanism.
(See the Figure 4-26, "Mounting the Carriage Assembly")
Disassembly and Assembly
O K
N G
Disassembly and Assembly
Figure 4-26. Mounting the Carriage Assembly
A D J U S T M E N T
After removing the carriage assembly, perform the Platen Gap
R E Q U I R E D
adjustment and Bi-d adjustment.
Revision C
89