Installation - Electrolux EOA6841 User Manual

38 www.electrolux.com
Problem
It takes more than
three minutes to
empty the water
tank or the water
leaks from the
steam inlet opening.
Steam and conden-
sation settle on the
food and in the ap-
pliance.
The display shows
F111.
The lamp does not
operate.
The display shows
"Demo". The appli-
ance does not heat
up. The fan does
not operate.
If you cannot find a solution to the prob-
lem yourself, contact your dealer or the
service centre.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

14. INSTALLATION

WARNING!
Refer to the Safety chapters.
Possible cause
There are lime deposits in
the appliance.
You left the dish in the appli-
ance for too long.
You did not correctly install
the CT Sensor into the
socket.
The lamp is defective.
The test mode is activated.
Check the water tank. Refer
to "Cleaning the water
tank".
Do not keep the dishes in
the appliance for longer
than 15 — 20 minutes after
the cooking ends.
Put the plug of core temper-
ature sensor as far as possi-
ble into the socket.
Replace the lamp.
1.
Deactivate the appli-
ance.
2.
Touch and hold
the appliance activates
and deactivates.
3.
Touch and hold
at the same time un-
til an acoustic signal
sounds and "d" goes
out.
The necessary data for the service centre
is on the rating plate. The rating plate is
on the front frame of the appliance cavity.
.........................................
.........................................
.........................................
Remedy
until
and