Maintenance - Worx WG166 Instructions For Use Manual

unit from contacting the ground. Take extra
caution while edging as objects can be thrown
from the trimmer line.
AUToMATIC LINE FEED SySTEM
When initially switching on the trimmer, a
small length of line is fed out.
A 'clattering' noise will be heard when the
lines hit the line cutter. DO NOT BE ALARMED
this is quit normal. After about 5 seconds the
line will be cut to the correct length and the
noise will reduce as the motor receives full
speed.
If the noise of the line being cut can't be heard,
more line will be fed out.
To feed more line, it is first necessary to allow
the trimmer to stop completely, then restart,
allowing the motor to reach full speed.
Repeat above until you hear the lines hitting
against the line cutter. (Do not repeat this
procedure more than 6 times)
To MANUALLy FEED THE LINE (See Fig
K)
If required line can be feed out manually
12 12
To operate, press and release manual line feed
button (13), while gently pulling out the lines
until the lines reach the line cutter.
If the line extends past the line cutter, too
much line has been fed out.
If too much line is fed out, remove the spool
cap and turn spool counter-clockwise until the
line is at the desired length.
To REMovE THE CAP
Press and hold in the two latches (15) (See Fig
L).
Pull cap away from the spool holder
When refitting the spool cap.
Keep all areas of the cap and spool holder
clean.
Replace the cap, pressing firmly down towards
the spool holder to ensure cap is fully located.
Check that the cap is correctly fitted by trying
to remove it without depressing the two
latches.
To REPLACE CUT LINE.
For your convenience it is recommended you
buy spool and line complete.
2-in-1 Cordless Lawn trimmer / Lawn edge trimmer EN
To fit spool and line complete:
Remove old spool.
Place new spool into cap with cut out areas
of the spool in line with eyelets.
Release line from cleat and feed line through
eyelet .
Refit the cap.
To fit nylon line only:
wARNING! Take approximately 10ft(3m)
of line. Insert 5/8"(15mm )of line into the
spool holes and wind line in the direction of
the arrows on the top of the spool.
Your Trimmer is designed to use only line with
a maximum diameter of 0.065"
IMPoRTANT: Leave approximately
4"(100mm) of line unwound and place into
cleat.
Care should be taken to ensure that the line is
neatly coiled on the spool. Failure to do so will
impair the efficiency of the automatic line feed.
Then fit spool as described in "To fit spool
and line complete".

maiNTENaNCE

After use, disconnect the battery from the
mains and check for damage. Your power
tool requires no additional lubrication or
maintenance. There are no user serviceable
parts in your power tool. Mains powered
trimmers should only be repaired by an
authorized repairer use only manufacturers
recommended replacement parts and
accessories.
Never use water or chemical cleaners to
clean your power tool. Wipe clean with a dry
cloth. Always store your power tool in a dry
place out of the reach of children. Keep the
motor ventilation slots clean. Keep all working
controls free of dust. If you see some sparks
flashing in the ventilation slots, this is normal
and will not damage your power tool.