Environmental Protection; Maintenance - Worx WG284E Manual

downward tilt of the cutting blades in the direction of
motion gives the best cutting results.
Side cutting
When trimming the sides of the hedge, begin at
the bottom and cut upwards, tapering the hedge
inward at the top. This shape will expose more of
the hedge, resulting in a more uniformed growth
BATTERY STATUS (See Fig. F )
•
Before starting or after use, press the button
beside the power indicator light on the machine
to check the battery capacity.
•
During operation, the battery capacity will be
indicated automatically by the battery power
indicator. The indicator constantly senses and
displays the battery condition as follows.
•
For the machine with 2 battery packs with
different power, the power indicator light
displays the battery condition with the lower one
of the two batteries.
Battery indicator
light status
Five green lights
( ) are
illuminated.
Two, three or four
green lights are
illuminated.
12
Only one green
light ( ) is
illuminated.
No light is
illuminated.
Only one light is
flashing twice per
cycle.
Only one light is
flashing three times
per cycle.
Only one light is
flashing four times
per cycle.

MAINTENANCE

Remove the battery from Hedge trimmer
before carrying out any adjustment, servicing
or maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to
Hedge trimmer
Battery condition
The two batteries are in a
highly charged condition.
The two batteries have a
remaining charge. The more
lights are illuminated, the
more battery capacity.
At least one battery is
almost depleted and needs
to be charged.
At least one battery is not
fully installed or battery
may be defective.
At least one battery is
over discharged (please
refer to the battery charge
condition), please recharge
the two batteries at once
before use again or storage.
At least one battery is hot,
wait for them cool down
before start again.
The machine is over load.
Remove tool from cutting
area and try again.
clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place. Keep
the motor ventilation slots clean. Keep all working
controls free of dust.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
EN