Table of Contents
Advertisement
Only use nylon line.
IMPORTANT - Always wind the line onto the upper
section of the spool first.
3. Manually winding the line (See Fig. M, N, O, P)
Take approximately 5 m line and insert 15 mm of line
into one of the holes in the upper section of the spool.
Wind the line in the direction of the arrows on the top
of the spool.
Leave approximately 100mm of line unwound and
place it into the cleat. Repeat on the lower section of
spool. Care should be taken to ensure that the line is
neatly coiled on the spool. Failure to do so will impair
the efficiency of the automatic line feed. Then fit the
spool as described above in "Changing the Line Spool".
STORING YOUR GRASS
TRIMMER
Always remove the battery pack from your
trimmer after use.
To store your GRASS trimmer
The trimmer is provided with a hanging slot for storing
the trimmer on the wall. (See Fig. Q)
Store in a dry place where the trimmer and battery can
be protected from damage.
MAINTENANCE
Always remove the battery pack from your
trimmer after use.
Always check the product prior to being used for any
damage.
After use, disconnect the battery from the tool and
check for damage.
Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts
in your power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean with a
dry cloth. Always store your power tool in a dry room
temperature location. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities
or retailer for recycling advice.
Cordless Grass Trimmer
WG183E
WG183E.X
15
Advertisement
Table of Contents
