Installing Dimm - SOLTEK SL-75KAV User Manual

75KAV/75KAV-X
WARNING!!!
• Make sure to unplug your power supply before adding or removing memory mod-
ules or other system components. Failure to do so may cause severe damage to
both your mainboard and expansion cards.
• Be careful when inserting or removing DIMM. Forcing a DIMM in or out of a socket
improperly may damage the memory module or the socket. Some DIMMs which con-
tain EDO or FTP DRAM are incompliant with the mainboard. The M/B supports 3.
3V true SDRAM DIMMs only.

Installing DIMM

• Make sure you have the correct memory module type for your mainboard.
• Insert the module(s) as shown below, DIMMs have 168-pins and two notches
that will be matched by the onboard DIMM socket. Memory modules are
installed by inserting them straight into the slot until they "click" in the right
place. They only fit in one direction, so do not force them in by a wrong
direction.
168-Pin DIMM Notch Key Definitions(3.3V)
Removing DIMM
• Press down the holding clips on both sides of a DIMM socket and the
module will be released from it.
DRAM Key Position Voltage Key Position
Unbuffered
20
3.3V