Kramer Protocol 3000 Commands - Kramer VP-4x1 CS User Manual

12.2

Kramer Protocol 3000 Commands

Command
#
ADL
ADL?
AUD-LVL
AUD-LVL?
AV
BUILD-DATE?
ETH-PORT
ETH-PORT?
FACTORY
INFO-IO?
INFO-PRST?
LOCK-FP
LOCK-FP?
MODEL?
NET-DHCP
NET-DHCP?
NET-GATE
NET-GATE?
NET-IP
NET-IP?
NET-MAC?
NET-MASK
NET-MASK?
P2000
P3000
PRIO
PRIO?
PROT-VER?
RESET
SIGNAL?
SN?
VERSION?
VID
VID?
VOL
VOL?
VOLUM
VOLUM?
34
Short
Form Description
Protocol handshaking
Set audio level in specific amplifier stage
Read audio volume level
ADL Set audio level in specific amplifier stage
ADL? Read audio volume level
Switch audio and video
Read device build date
ETHP Change protocol Ethernet port
ETHP? Read protocol Ethernet port
Reset to factory default configuration
Read in/out count
Read maximum preset count
LCK Lock front panel
LCK? Read Lock front panel
Read device model
NTDH Set DHCP mode
NTDH? Read subnet mask
NTGT Set gateway address
NTGT? Read subnet mask
NTIP Set IP address
NTIP? Read IP address
NTMC Read MAC address
NTMSK Set subnet mask
NTMSK? Read subnet mask
Switch to Protocol 2000
Switch to Protocol 3000
Set switching priority
Get switching priority
Read device protocol version
Reset device
Get valid/invalid status
Read device serial number
Read device firmware version
Switch Video only
Get Video switch state
Set simple audio volume
Read simple audio level
VOL Set simple audio volume
VOL? Read simple audio level
Permission
End User
End User
End User
End User
Administrator
End User
End User
End User
End User
End User
End User
End User
Administrator
End User
End User
End User
End User
End User
VP-4x1CS - Protocol 3000