Operating The Vp-4X1Cs 4X1 Pc Graphics Clean Switcher; Operating The Vp-4X1Cs Locally - Kramer VP-4x1 CS User Manual

4x1 pc graphics clean switcher
Table of Contents

Advertisement

7
Operating the VP-4x1CS 4x1 PC Graphics
Clean Switcher
The VP-4x1CS can be operated:
Locally using the front panel buttons (see
Remotely using:
7.1

Operating the VP-4x1CS Locally

This section describes:
Setting a priority Input (see
Switching Between Protocol 2000 and Protocol 3000 (see
Locking and unlocking the front panel buttons (see
Resetting the device to factory default settings (see
Upgrading the VP-4x1CS firmware (see
EDID Handling (see
7.1.1
Setting a Priority Input
When a priority input is set, the VP-4x1CS cycles through the inputs from 1 to 4
(beginning with the priority input) looking for a live signal. If there is no signal on
the priority input the device cycles through the inputs (from low to high) and
selects the first input that is encountered with a live signal.
Note: When a priority Input is selected, the device does not perform clean
switching.
Note: For clean switching, all extracted sources must be of the same resolution.
14
The embedded Web pages (see
The K-Single Application (see
Section
VP-4x1CS - Operating the VP-4x1CS 4x1 PC Graphics Clean Switcher
Section
Section
7.2)
Section
7.3)
Section
7.1.1)
Section
7.1.6)
7.1)
Section
7.1.2)
Section
7.1.3)
Section
7.1.4)
7.1.5)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VP-4x1 CS and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Vp-4x1cs

Table of Contents