Trade-wind ESH5200 Installation Instructions Manual

Installer: Please leave Installation Instructions with the range hood.
Owner: Please keep Installation Instructions for local inspector's use and for future reference.
CONTENTS:
U
Part 1 Unpacking the Range Hood
Part 2 Planning the Installation
Part 3 Installation
Part 4 Use & Care
Part 5 Electrical Connection (Copy to Electrician)
Before beginning installation, please thoroughly read and become familiar with these instructions. Installation and
service must be completed by a qualified person. Failure to properly install this product may void the warranty.
WARNINGS / CAUTION: Must be followed carefully to avoid personal injury.
IMPORTANT: Must be followed carefully to avoid damage or incorrect installation.
TIPS: Contain helpful information to facilitate installation.
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY TO
PERSONS OBSERVE THE FOLLOWING:
1. Use this unit only in the manner intended by the manufacturer. If you have any questions, please contact the
manufacturer at the address or telephone number listed in the warranty.
2. Before servicing or cleaning unit, switch power off at service panel and lock service panel to prevent power from
being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a
prominent warning device, such as a tag to the service panel.
3. Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes
and standards, including fire-rated construction codes and standards.
4. Sufficient air is needed for proper combustion and exhausting of gases through the chimney of fuel burning
equipment to prevent back-drafting. Follow the heating equipment manufacturer's guidelines and safety standards
such as those published by the National Fire Protection Association (NFPA) and the American Society for Heating,
Refrigeration and Air Conditioning Engineers (ASHRAE) and the local code authorities.
5. When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
6. Ducted fans must always be vented to the outdoors.
7. Do not connect this unit to any solid-state speed control device.
8. To reduce the risk of fire, use only steel ductwork.
9. This unit must be grounded.
TO REDUCE THE RISK OF RANGE TOP GREASE FIRE:
1. Keep fan, filters and grease laden surfaces clean. Grease should not be allowed to accumulate on filter or fan.
2. Always turn hood ON when cooking at high heat or when cooking flaming foods.
3. Use high range settings on range only when necessary. Heat oil slowly on low or medium setting.
4. Don't leave range unattended when cooking.
5. Always use cookware and utensils appropriate for the type and amount of food being prepared.
WARNING:
RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING*:
1. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn off the burner. BE CAREFUL
TO PREVENT BURNS. If the flames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT.
2. NEVER PICK UP A FLAMING PAN—YOU MAY BE BURNED.
3. DO NOT USE WATER, including wet dishcloths or towels. A violent steam explosion will result.
Item No. 0BH-00-004, Revised 12/10/07

READ AND SAVE THESE INSTRUCTIONS

TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A
Copyright © 2007 Universal Metal Industries, Inc.
INSTALLATION INSTRUCTIONS &
USE & CARE GUIDE
Euro-style Range Hood
ESH5200
Page 1