Trade-wind 3000 Slim Line Series Installation Instructions & Use & Care Manual

Trade-wind 3000 Slim Line Series Installation Instructions & Use & Care Manual

Advertisement

Quick Links

***ATTENTION***
PLEASE REMOVE THE
RIGHT SIDE BAFFLE
FILTER TO LOCATE YOUR
NEW REMOTE CONTROL.
Revised 6/11/18
Copyright © 2018 Trade-Wind Manufacturing, LLC
Proverbs 22:29
Page 1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 3000 Slim Line Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Trade-wind 3000 Slim Line Series

  • Page 1 ***ATTENTION*** PLEASE REMOVE THE RIGHT SIDE BAFFLE FILTER TO LOCATE YOUR NEW REMOTE CONTROL. Revised 6/11/18 Copyright © 2018 Trade-Wind Manufacturing, LLC Proverbs 22:29 Page 1...
  • Page 2 Revised 6/11/18 Copyright © 2018 Trade-Wind Manufacturing, LLC Proverbs 22:29 Page 2...
  • Page 3 -- For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapors. WARNING – TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE: Revised 6/11/18 Copyright © 2018 Trade-Wind Manufacturing, LLC Proverbs 22:29 Page 3...
  • Page 4 When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities. d) Ducted fans must always be vented to the outdoors. WARNING -- TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCTWORK. Revised 6/11/18 Copyright © 2018 Trade-Wind Manufacturing, LLC Proverbs 22:29 Page 4...
  • Page 5: Planning The Installation

    30” above the stove. 30423RC NOTE: Use of duct cover is optional. Unit can be installed alone to be placed under any cabinet. Revised 6/11/18 Copyright © 2018 Trade-Wind Manufacturing, LLC Proverbs 22:29 Page 5...
  • Page 6: Mounting Instructions

    5) Once mounting bracket has been secured to the wall, lift the hood and proceed to slide the mounting harness onto the mounting bracket clips on the wall. ** Ensure that both mounting bracket and harness are seated securely together. Revised 6/11/18 Copyright © 2018 Trade-Wind Manufacturing, LLC Proverbs 22:29 Page 6...
  • Page 7: Electrical Connection

    If you can hit a stud with a lag bolt, only x2 per side should be sufficient. If toggle bolts are required, use all four holes per bracket. It may also be necessary to screw through the Revised 6/11/18 Copyright © 2018 Trade-Wind Manufacturing, LLC Proverbs 22:29 Page 7...
  • Page 8 MR16/GU10 LED flood light bulbs. They can be purchased at most home or grocery stores. The bulbs provided with the unit are 3.5 watt, 350 lumen, and 3000K (color temperature). Revised 6/11/18 Copyright © 2018 Trade-Wind Manufacturing, LLC Proverbs 22:29 Page 8...
  • Page 9: Range Of Remote Control

    The infrared transmitter at the top of the remote must be pointed in the direction of the electronic control at the right front of your hood or liner. Range distance will vary depending on your installation, but see diagram below for approximate range area. Revised 6/11/18 Copyright © 2018 Trade-Wind Manufacturing, LLC Proverbs 22:29 Page 9...
  • Page 10: Warranty

    What is NOT Covered:  Normal maintenance and service of any product that has been subject to misuse, negligence, ® accident, or installation inconsistent with the recommended Trade-Wind Installation Instructions ® and Trade-Wind Best Practices Guidelines.
  • Page 11: Best Practices

    Configure the ventilation duct run to be as short and as direct to the outside as possible. Minimize the number of elbows and transition fittings used. Complex or long runs should be reviewed by a qualified installer. Revised 6/11/18 Copyright © 2018 Trade-Wind Manufacturing, LLC Proverbs 22:29 Page 11...
  • Page 12 In-line dampers must be installed so that the exhaust air flow will open the butterfly blades. For horizontal duct runs, the in-line damper must be installed so that the hinge between the two Revised 6/11/18 Copyright © 2018 Trade-Wind Manufacturing, LLC Proverbs 22:29 Page 12...
  • Page 13 The “radius” is one-half the diameter of a round duct, e.g., ½ of a 10” round duct is 5”. 3.1416 is “Pi”, the “constant” used when calculating the area of a circle. Revised 6/11/18 Copyright © 2018 Trade-Wind Manufacturing, LLC Proverbs 22:29 Page 13...

This manual is also suitable for:

30303rc30423rc30363rc

Table of Contents