Table of Contents
Advertisement
5.4.1 Putting on the lap seatbelt
with catch
Pull both belt halves to the front and
slide the catch halves together so that
they latch together (fig. 39.1). Then
carry out a pull test.
You open the lap seatbelt by pressing in
the red unlocking button (fig. 39.2/
5.4.2 Putting on the lap seatbelt
with Velcro fastener
Guide the belt end with the Velcro
strip through the clasp and then close
the Velcro fastener. Then carry out a
pull test.
Attention:
Make sure that there are no objects
!
trapped under the seatbelt! – Thus
you avoid painful pressure points.
5.4.3 Setting belt length
Remark:
The lap seatbelt should not be too
tight!
30
1
).
39.2
6. Care and main-
tenance
6.1 Care
Upholstered seat/backrest:
Clean the cushion with warm water. In
the case of stubborn soiling, the fabric
can be washed with a standard wash-
ing powder for delicate fabrics. Spots
can be removed with a sponge or a soft
brush. Do not soak!
Do not use aggressive cleaning agents
e.g. solvents, or hard brushes etc.
Rinse with clear water and allow to dry.
Rinse with clean water and leave to dry
naturally. To disinfect, use commercial
brands and observe the instructions for
use given on the product.
Plastic parts:
Take care of these by means of stand-
ard plastics cleaning agents. Always
observe the specific product informa-
tion.
Finish:
The high quality finish ensures an opti-
mum of protection against corrosion. If
the surface finish is damaged by scratch-
es or similar, touch it up with a varnish
pen available from us. Occasional appli-
cation of a light cover of oil to all moving
parts (see also Maintenance Instructions)
will ensure that your wheelchair will give
you many years of service.
31
Advertisement
Table of Contents
