Intermec CK30 User Manual page 43

Chapter 2 — Configuring the CK30
When using the Configuration Utility, you may not see a
parameter until you enable or disable a value for another key
field. For example, you will not see IP Settings unless you disable
DHCP. You may also not see a parameter if your computer does
not support a particular feature.
Use the following diagram to find the commands you need to
use to configure your CK30s. These screens are do not represent
the exact information you will see on your CK30. They have
been modified to show you how the information is structured.
Configuration Utility Menus at a Glance
CK30 Handheld Computer User's Manual 31