5
End Device Operation
Figure 5-6. Utility Program - Setup Transmitter Screen
If you have not already placed your End Device into the "Setup" mode you
should do this now before continuing. After your unit has been placed into the
"Setup" mode click the "Next >" button to proceed and continue setting up your
unit.
Figure 5-7. Utility Program - Establish Link Screen
After successful communication between your connector/transmitter has been
established you can click the "Next >" button to proceed and continue setting up
your connector/transmitter. If you did not receive this confirmation of proper
communication you should click the "Back" button to try connecting again.
5-5