Table of Contents
Advertisement
5
End Device Operation
STEP 1. Enter the "SETUP" mode.
To place your transmitter into the "SETUP" mode for programming follow this
procedure.
STATUS
LOW BATTERY
SETUP
USB
ON/OFF
Figure 5-2. Main Transmitter Board
Press and hold the "ON/OFF" button. While the "ON/OFF" button is being
held, press the "SETUP" button one time and then release the "ON/OFF"
button. The green (TX) indicator on the front of your device should be blinking
at a steady rate. This indicates your End Device is ready to run the configuration
utility software.
STEP 2. Launch Setup Utility Program.
To launch the End Device setup utility program on your PC begin by accessing
the "Programs" list under your "Start Menu".
Scroll through the list of to find the Omega "TC-Central" folder, then select the
End Device Configuration Program.
Figure 5-3. Launch Setup Utility
5-3
Advertisement
Table of Contents
