Setup Review; Sealing; Do's And Don'ts; Capacity - Cardinal HSDC series Operation Manual

The HSDC allows several operational parameters to be reviewed and changed as necessary
without having to break the calibration seal and enter the setup and calibration mode. The setup
review allows changes to be made to the power up zero setting, the automatic shutoff and sleep
mode delay times, push button tare.
To enter the setup review mode, simply turn the HSDC off, then press and hold any key other than
ON/ZERO or the OFF keys and press the ON/ZERO key. The display will prompt for the power up
zero selection. Refer to the instructions listed in the Calibration Procedure section of this manual for
information on how to change these parameters.
The parameters in the setup review will be processed in the following sequence:
Fine Span
The span can be fine-adjusted while the indicator is on by pressing and holding the calibration
switch and pressing the ON/ZERO or NET key:
To attach the seals, first make certain the two cover plate retaining screws are snug then thread the
seal wires through the hole in the screw heads as shown in the calibration section of this manual.
1. DO hang the scale from a support that is strong enough to support the weight of the scale plus
the weight of the material to be weighed. The more rigid the support the better.
2. DON'T shock load your HSDC hanging scale with weights greater than 10 percent of the scale's
capacity by throwing the weight on the scale.
3. DO replace batteries as soon as the weight display shows the low battery signal.
4. DON'T hose down or submerse the scale in any liquid.
5. DO use only a damp cloth and mild detergent to clean the outside of the scale.
6. DON'T disassemble the scale. There are no user-serviceable components within the scale.

SETUP REVIEW

POWER UP ZERO
AUTOMATIC SHUTOFF TIME
SLEEP MODE TIME
PUSH BUTTON TARE
Calibration Switch + ON/ZERO = increase
Calibration Switch + NET = decrease
Go to Sealing Instructions
SEALING INSTRUCTIONS

DO'S and DON'TS

10