Display Codes; Capacity - Cardinal HSDC series Operation Manual

Pressing the TARE key will cause the currently displayed gross weight to be stored as the new tare
weight and cause the scale to enter the net weight display mode. The net weight display mode is
indicated by turning on the net annunciator. For example, on a HSDC-20, if the displayed gross
weight is 2.00 lb and you press the TARE key, the 2.00 lb would be entered as the new tare weight.
The scale would then enter the net weight mode and subtract the 2.00 lb tare value from the gross
weight displaying a net weight of 0.00 lb. If you added another 2.00 lb to the platform, the display
would indicate 2.00 lb of net weight. Pressing the GROSS key would return the scale to the gross
weight display 4.00 lb. NOTE: Remember the scale will only weigh to its maximum capacity. Any
combination of NET plus TARE weights over the scale capacity will result in a overload condition
and display ot. For example, using the HSDC-20 from above, with tare weight of 2.00 lb, adding
19.00 lb to the platform will cause an overload condition. This is because 2.00 lb tare weight plus
19.00 lb load weight equals 21.00 lb gross weight, which exceeds the capacity of the scale.
During operation of the HSDC hanging scale you may encounter a special display message. The
following lists display codes and their meaning.
DISPLAY
-oC-
Scale overloaded, remove excess load to resume operation.
Motion is present when attempting to power-up, zero the weight display or enter a
UnSt
tare value.
UnLd
The weight on the scale exceeds the zero range on power-on. Remove the load.
LoAd=
The scale load is less than the zero range on power-on.
-oF-
Attempting to display a negative number less than -999.
CALb
Indicates that the scale has not been calibrated or has been interrupted during the
calibration process.
Err
Disallowed keyboard entry: attempted to zero with the weight outside the zero
range.
TARE WEIGHT ENTRY, Cont.

DISPLAY CODES

MEANING
5