Shuttle FN45 User Manual page 65

Video Off Method
This determines the manner in which the monitor is blanked.
V/H SYNC+Blank This selection will cause the system to turn off
Blank Screen
DPMS Support
Ø The choice: V/H SYNC+Blank, Blank Screen, or DPMS Support.
HDD Power Down
The IDE hard drive will spin down if it is not accessed within a specified
length of time. Options are from 1 Min to 15 Min and Disabled.
Ø The choice: Disabled or 1 Min~15 Min.
HDD Down In Suspend
The item allows you to enable or disable the HDD Down In Suspend.
Ø The choice: Enabled or Disabled.
Soft-Off By PBTN
Under ACPI you can create a software power down. In a software
power down, the system can be resumed by Wake UP Alarms. This
item lets you install a software power down that is controlled by the
power button on your system. If the item is set to Instant-Off, then the
power button causes a software power down. If the item is set to Delay
4 Sec., then you have to hold the power button down for 4 seconds to
cause a software power down.
Ø The choice: Delay 4 Sec. or Instant-Off.
WOL(PME#) From Soft-Off
If this item sets to Enabled, the system power will be turned on when the
LAN port receives an incoming signal.
Ø The choice: Enabled or Disabled.
WOR(RI#) From Soft-Off
If this item is enabled, it allows the system to resume from a software
power down or power-saving mode whenever there is an incoming call
to an installed fax/modem. You have to connector the fax/modem to
the mainboard.
Ø The choice: Enabled or Disabled.
USB Resume from S3
If you are using USB devices, and the ACPI Suspend Type is set to S3 or
S1&S3, enable this item to have USB devices wake up the system from
power saving mode.
Ø The choice: Enabled or Disabled.
the vertical and horizontal synchronization
ports and write blanks to the video buffer.
The item only writes blanks to the video buffer.
Initial display power management signaling.
- 59 -