Jumper Settings - Shuttle FN45 User Manual

3.2 Jumper Settings

Several hardware settings are made through the use of mini jumpers to con-
nect jumper pins on the mainboard. Pin #1could be located at any corner of
jumpers, and the corner with a white right angle stands for Pin #1. There are
several types of Pin #1 as shown below:
3-pin and multi-pin (>3) jumpers shown as follows:
Pin #1 to the left:
Pin #1 on the top:
Pin #1 to the right:
Pin #1 on the bottom:
Jumpers with two pins capped are shown as
for Open [Off]. To do this, please place a plastic mini cap on the desired pair
of pins.
Caution!
1. Do not remove the mainboard from its antistatic protective packaging
until you are ready to install it.
2. Carefully hold the mainboard by its edges and avoid touching its compo-
nents. When putting the mainboard down, place it on top of its original
packaging film, with the component side up.
3. Wear an antistatic wrist strap or take other suitable measures to prevent
electrostatic discharge (ESD) as handling this equipment.
- 23 -
for Close [On] or