Shuttle FN45 User Manual page 63

Onboard SuperIO Device
Press <Enter> to enter the sub-menu of detailed options.
Onboard FDC Controller
This item specifices onboard floppy disk drive controller. This setting
allows you to connect your floppy disk drives to the onboard floppy
connector.
Ø The choice: Enabled or Disabled.
Onboard Serial Port 1
This option is used to assign the I/O address and interrupt request (IRQ)
for the onboard serial port 1 (COM1).
Ø The Choice: Disabled, 3F8-IRQ4, 2F8-IRQ3, 3E8-IRQ4, 2E8-IRQ3,
or Auto.
Onboard Infrared Port
This option is used to assign the I/O address and interrupt request (IRQ)
for the onboard infrared port.
Ø The Choice: Disabled, 3F8-IRQ4, 2F8-IRQ3, 3E8-IRQ4, 2E8-IRQ3,
or Auto.
UART Mode Select
This item allows you to select an operating mode for the IrDA infrared.
Ø The choice: IrDA, ASKIR, or SCR.
UR2 Duplex Mode
This item allows you to select the IR half or full duplex function.
Ø The choice: Full or Half.
Onboard Parallel Port
Allows you to determine an I/O address and interrupt request (IRQ) for
the onboard parallel port.
Ø The choice: 378/IRQ7, 278/IRQ5, 3BC/IRQ7, or Disabled.
Parallel Port Mode
Select an operating mode for the onboard parallel port. Select SPP
unless you are certain your system supports other modes.
Ø The choice: SPP, EPP, ECP, or ECP+EPP.
ECP Mode Use DMA
When the parallel port mode is set to ECP, this item becomes seletable.
Ø The choice: 1 or 3.
- 57 -