B.1 Setting serial data for expansion
The fourteen kinds of timings below are already programmed in this
module. The input synchronous signals are automatically recognized.
Note 1:
Note 2:
Note 3:
28
FPM-3150 Series User's Manual
Even if the preset timing is entered, a little adjust-
ment of the functions such as Horizontal period,
CLK-delay and display position, are required. The
adjusted values are memorized in every preset
number.
This module recognizes the synchronous signals
with near preset timing of the frequency of the HS
and Vsync, even in the case that the signals other
than the preset timing that were entered.
Because adjustments may not fit, such as differing
magnifying ratios or, in the case that you use it
except for the display timing that was preset.