Table of Contents
Advertisement
Chapter 2: Getting Started
CAUTION:
If you have purchased the bicycle by mail order or through a sales channel whereas your
new G Plus Genesis 500 is still in the box, it is recommended you read Chapter 3 "Basic Instructions"
section g "Before your first ride" prior to your first ride. There may be additional adjustments required due
to harsh shipping by the freight carrier.
a) Unpacking your box
Your G Plus Genesis 500 arrives fully assembled in it's box other than need for the insertion of the seatpost and
handlebar stem. You can learn on how to insert the seatpost and adjust for your height in Chapter 3 "Basic
Instructions" section b "Adjusting the saddle". The insertion of the stem and tightening of the stem bolt is detailed on
Chapter 3 "Basic Instructions' section c "Installing and adjusting the stem".
The G Plus Genesis 500 has been fully tested and adjusted prior to being packed in the Heavy Duty double wall
box with expanding foam fitting system. To remove the G Plus Genesis 500 from it's box, simply remove the top
layer of expanded foam (wrapped in a thin film) and place one hand under the front portion of the frame and the
other hand under the center of the frame. Pull up slowly and the bicycle will lift out of the box. Remove the bottom
layer of expanded foam (if attached to bicycle) and set the bicycle down by balancing the bicycle on the opened
kick stand and both wheels. The kick stand also performs as a crankset protector. To unfold the bicycle, read the
following paragraph, section b.
b) Folding and unfolding (SEE PHOTOS BELOW AND NEXT PAGE)
Folding: your bicycle has the ability to fold for easy storing and transporting. There is a quick release lever that
will allow the bicycle to fold into an area half of the original size. The pedals can also be folded by squeezing the 2
metal tabs on the outside edges of each pedal, pulling the pedal outwards and then pushing the pedal down. To
fold the bicycle you should stand on the right side of the bicycle (the crank set and chain side) and then un-clasp
the frame hinge lever after turning the small safety release latch up. You will now be able to fold the bicycle in
half. When picking up the bicycle once it has been folded, it is easy to lift by placing one hand under the front
portion of the frame and one hand under the center of the frame in front of the seat tube. If folding the bicycle is to
allow for the ability to store in a closet or small space, after folding you can roll the bicycle on its own wheel using
the saddle nose and handlebar to guide it to the storing area.
Unfolding: your bicycle can easily be unfolded in a matter of seconds. Stand at the right side of the bicycle (the
crank set and chain side) and place one hand around the front portion of the frame and one hand under the
center portion of the frame behind the frame hinge. Open the frame to a straight position until the spring in the
hinge clasp lever locks the lever in place. Close the lever completely and turn the hinge safety release latch down
(clockwise) to lock the frame hinge lever in place. For some, it may be easier to use the handlebar stem and seat
post to unfold or fold the bicycle. Please make sure the seat post and handlebar stem are tight and secured.
6
Hide quick links:
Advertisement
Table of Contents
