Replacing A Tube Or Tire - Prodeco Technologies Genesis 500 User Manual


Once tightened, close the quick release lever with force to clamp and lock the axle into the dropouts.
The force must be strong enough for the axle not to become loose later. It should take some effort to
close the lever but not so much that you are straining or feel you are damaging the quick release. You
should not be able to open the quick release lever with 1 finger.

Test to see if the quick release lever will open with 1 finger, if it opens you must perform the previous
step again until the quick release lever clamp is tight.
d. Replacing a tube or tire
Read the previous sections a. and b. to learn how to remove and replace the front and rear wheel. You will need to
understand how to remove the wheel prior to replacing a tube or tire. This section only explains how to remove the
tire from the rim and how to replace a tube.
Before explaining how to replace a tube and tire, details on the G Plus Genesis 500's tubes and tires are
discussed. Tubes and tires are 2 of the most important components on your new bicycle and must always be in
optimum condition. It is important you understand about the tubes and tires used on your bicycle.
The G Plus Genesis 500 uses high-performance KENDA Low Resistance UNI-Directional tires with a 40-65 PSI
25