Chapter 1 - Product Description And Specifications; Related Documentation; Safety; General Safety - Multitech MultiModem Cell MTCBA-E1 User Manual

Chapter 1 – Product Description and Specifications

Related Documentation

The following table describes additional documentation for each model.
Model
MultiModem MTCBA-E1 (EDGE)
MultiModem MTCBA-G2 (GPRS)
MultiModem MTCBA-C1 (CDMA)
MultiModem MTCBA-H5 (HSPA+)

Safety

General Safety

The modem is designed for and intended to be used in fixed and mobile applications. Fixed means the device is
physically secured at one location and cannot be easily moved to another location. Mobile means the device is
used in other than fixed locations.
Caution: Maintain a separation distance of at least 20 cm (8 inches) between the transmitter's antenna and the
body of the user or nearby persons. The modem is not designed for or intended to be used in portable
applications within 20 cm (8 inches) of the user's body.

RF Interference Issues

Follow any special regulations regarding the use of radio equipment due to the possibility of radio frequency (RF)
interference. Follow the safety advice given below.
●
Switch OFF your wireless device when in an aircraft. Using cellular telephones in an aircraft may endanger
aircraft operation, disrupt the cellular network, and is illegal. Failing to observe this restriction may lead to
suspension or denial of cellular telephone services to the offender, legal action, or both.
●
Switch OFF your wireless device when around gasoline or diesel-fuel pumps and before filling your vehicle
with fuel.
●
Switch OFF your wireless device in hospitals and any other place where medical equipment may be in use.
●
Respect restrictions on the use of radio equipment in fuel depots, chemical plants, or where blasting
operations are in progress.
●
Operating your wireless device close to other electronic equipment may cause interference if the equipment
is inadequately protected. Observe any warning signs and manufacturers' recommendations.
6
Additional Documentation
You can configure the MultiModem MTCBA-E1 wireless router using the
EDGE AT Commands. For more information refer to the Reference Guide
for the MultiModem Wireless EDGE Modems, part number S000474x.
You can configure the MultiModem MTCBA-G2 wireless modem using
the GPRS AT Commands. For more information, refer to the Reference
Guide for the MultiModem Wireless GPRS Modems, part number
S000463x
You can configure the MultiModem MTCBA-C1 wireless router using the
CDMA-C1 AT Commands. For more information, refer to the Reference
Guide for the MultiModem Wireless CDMA-C1 Modems, part number
S000478x.
You can configure the MultiModem MTCBA-H5 wireless router using the
HSPA+ AT Commands. These commands are documented in the
Reference Guide part number S000528x.
MultiModem Cell User Guide