Security Settings In Windows Vista - ZyXEL Communications NWD2205 User Manual

Chapter 4 Station Mode
and PIN - Use this Device's PIN in the Adapter screen. The following screen
displays.
Figure 47 WPS: PIN - Use this Device's PIN
The following table describes the labels in this screen.
Table 18 WPS: PIN - Use this Device's PIN
LABEL
This device's PIN
Start

4.7 Security Settings in Windows Vista

When you use the NWD2205 in Windows Vista, the procedure for setting up WPA,
WPA2 and 802.1x security settings is different from that of other operating
systems (other security types are not affected).
The procedures for setting up WPA, WPA2 or 802.1x in Vista are the same.
However, the procedure differs depending on whether you use PEAP (Protected
Extensible Authentication Protocol) or TLS (Transport Layer Security) encryption.
Consult your network administrator if you are unsure which type of encryption to
use.
See Section 4.7.1 on page 71
TLS.
70
DESCRIPTION
This is the NWD2205's Personal Identification Number
(PIN). This field is read-only. Enter the number that
displays in this field into the configuration interface of the
other WPS-enabled device.
Note: Each time this screen displays, the PIN is
different. The PIN is valid for only one WPS
transaction.
Click this to start WPS. You must start WPS on the other
WPS-enabled device within two minutes.
to use PEAP, or see Section 4.7.2 on page 72
NWD2205 User's Guide
to use