Wps: Pin - Use The Pin From The Ap Or Wireless Router; Security Settings In Windows Vista - ZyXEL Communications NWD-270N User Manual

4.6.3 WPS: PIN - Use the PIN from the AP or Wireless Router

This screen allows you to use the WPS Personal Identification Number mode, by entering the
PIN from another WPS-enabled device into the NWD-270N's utility. See
page 36 for more information. Select WPS and PIN - Use the PIN from the AP or Wireless
Router in the Adapter screen. The following screen displays.
Figure 48 WPS: PIN - Use the PIN from the AP or Wireless Router
The following table describes the labels in this screen.
Table 19 WPS: PIN - Use the PIN from the AP or Wireless Router
LABEL
AP or Router's PIN
Start

4.7 Security Settings in Windows Vista

When you use the NWD-270N in Windows Vista, the procedure for setting up WPA, WPA2
and 802.1x security settings is different from that of other operating systems (other security
types are not affected).
The procedures for setting up WPA, WPA2 or 802.1x in Vista are the same. However, the
procedure differs depending on whether you use PEAP (Protected Extensible Authentication
Protocol) or TLS (Transport Layer Security) encryption. Consult your network administrator
if you are unsure which type of encryption to use.
See Section 4.7.1 on page 62
TTLS (Tunneled TLS) is not available when using Windows Vista, at the time
of writing.
NWD-270N User's Guide
DESCRIPTION
Enter the PIN from your AP or wireless router in this field before you
click Start.
Click this to start WPS. You must start WPS on the other WPS-
enabled device within two minutes.
to use PEAP, or see Section 4.7.2 on page 63
Chapter 4 Station Mode
Section 3.4.2 on
to use TLS.
61