See Also...
The terms and concepts introduced in
as well.
5.1.3 Before You Begin
Make sure the ZyXEL Utility is already installed. See the Quick Start Guide for
more.
To bridge your wired and wireless network using the NWD2205, the following
requirements must be met:
• The NWD2205 must be installed on a computer connected to the wired network.
• Either bridge the two interfaces (wireless and wired) on the computer (using the
Configuration screen) or configure network sharing.
• Set the wireless station's IP address to be dynamic if you want the wireless
stations to access the wired network or the Internet through the NWD2205.
Refer to
Appendix A on page 101
address.
5.2 AP Mode Screen Summary
This section describes the ZyXEL Utility screens while in AP Mode.
Figure 54 ZyXEL Utility Menu Summary
The following table describes the menus.
Table 19 ZyXEL Utility Menu Summary
TAB
Link Info
Configuration
MAC Filter
NWD2205 User's Guide
Chapter 4 on page 49
for how to configure your computer's IP
DESCRIPTION
Use this screen to see your current connection status, configuration and
data rate statistics.
Use this screen to configure wireless LAN settings.
Use this screen to configure which computer(s) you want access to the
wireless LAN through the NWD2205.
Chapter 5 AP Mode
apply to this chapter
77