Wps: Pin - Use The Pin From The Ap Or Wireless Router; Security Settings In Windows Vista; Figure 44 Wps: Pin - Use The Pin From The Ap Or Wireless Router; Table 18 Wps: Pin - Use The Pin From The Ap Or Wireless Router - ZyXEL Communications NWD271N User Manual

4.6.3 WPS: PIN - Use the PIN from the AP or Wireless Router

This screen allows you to use the WPS Personal Identification Number mode, by entering the
PIN from another WPS-enabled device into the NWD271N's utility. See
41 for more information. Select WPS and PIN - Use the PIN from the AP or Wireless
Router in the Adapter screen. The following screen displays.

Figure 44 WPS: PIN - Use the PIN from the AP or Wireless Router

The following table describes the labels in this screen.

Table 18 WPS: PIN - Use the PIN from the AP or Wireless Router

LABEL
AP or Router's PIN
Start

4.7 Security Settings in Windows Vista

When you use the NWD271N in Windows Vista, the procedure for setting up WPA, WPA2
and 802.1x security settings is different from that of other operating systems (other security
types are not affected).
The procedures for setting up WPA, WPA2 or 802.1x in Vista are the same. However, the
procedure differs depending on whether you use PEAP (Protected Extensible Authentication
Protocol) or TLS (Transport Layer Security) encryption. Consult your network administrator
if you are unsure which type of encryption to use.
See Section 4.7.1 on page 68
TTLS (Tunneled TLS) is not available when using Windows Vista, at the time
of writing.
NWD271N User's Guide
DESCRIPTION
Enter the PIN from your AP or wireless router in this field before you
click Start.
Click this to start WPS. You must start WPS on the other WPS-
enabled device within two minutes.
to use PEAP, or see Section 4.7.2 on page 69
Chapter 4 ZyXEL Utility - Windows
Section 3.4.2 on page
to use TLS.
67