Security Settings In Windows Vista; Using Peap In Vista; Figure 45 Wps: Pin - Use The Pin From The Ap Or Wireless Router; Table 19 Wps: Pin - Use The Pin From The Ap Or Wireless Router - ZyXEL Communications NWD-210N - V1.0 User Manual

Chapter 4 Wireless Configuration

Figure 45 WPS: PIN - Use the PIN from the AP or Wireless Router

The following table describes the labels in this screen.

Table 19 WPS: PIN - Use the PIN from the AP or Wireless Router

LABEL
AP or Router's PIN
Start

4.6 Security Settings in Windows Vista

When you use the NWD210N in Windows Vista, the procedure for setting up WPA, WPA2
and 802.1x security settings is different from that of other operating systems (other security
types are not affected).
The procedures for setting up WPA, WPA2 or 802.1x in Vista are the same. However, the
procedure differs depending on whether you use PEAP (Protected Extensible Authentication
Protocol) or TLS (Transport Layer Security) encryption. Consult your network administrator
if you are unsure which type of encryption to use.
See section
use TLS.
TTLS (Tunneled TLS) is not available when using Windows Vista, at the time
of writing.

4.6.1 Using PEAP in Vista

Take the following steps to set up WPA, WPA2 or 802.1x security using PEAP in Windows
Vista.
1 Either select the AP to which you want to connect in the Site Survey screen (see
4.3 on page
64
DESCRIPTION
Enter the PIN from your AP or wireless router in this field before you
click Start.
Click this to start WPS. You must start WPS on the other WPS-
enabled device within two minutes.
Section 4.6.1 on page 64
49), or configure a profile in the normal way (see
to use PEAP, or see section Section 4.6.2 on page 65
Section
Section 4.4 on page 56).
NWD210N User's Guide
to