Installation; Section 2: Framing - Montigo RP620 Installation & Maintenance Manual

Installation Sequence
■ Unpacking and set-up
■ Framing
■ Fireplace placement and securing
■ Power connection
■ Gas connection
■ Power vent termination installation.
■ Vent installation.
■ Test firing.
■ Steel framing.
■ Wall boarding / finishing
■ Installation of windows / accessories
Installation and repairs should be done by a qualified contractor
and must conform to:
• Installations in Canada must conform to the local codes or
in the absence of local codes to the current version of Natural Gas
and Propane Installation Code, CSA B149. Electrical Installations
must conform to the local codes or, in the absence of local codes,
to the current version of Canadian Electrical Code, CSA C22.1.1
• Installations in the USA must conform to the local codes
or in the absence of local codes to the current version of National
Fuel Gas Code, ANSI Z223.1/NFPA 54. Electrical Installations must
conform to the local codes or, in the absence of local codes, to the
current version of the National Electrical Code, ANSI/NFPA 70.
See Appendix B for installation within the State of Massachusetts.
Fuel Type
Verify that your fireplace is compatible with your available gas
type. Natural Gas or Propane shown by "N" or "L" in your model
number on rating plate.
XG0777 - 100113.1

Installation

Install location:
The RP-Series fireplace may be installed in any location that
maintains proper clearances to air conditioning ducts, electrical
wiring, and plumbing. Safety, as well as efficiency of operation,
must be considered when selecting the fireplace location. Try
to select a location that does not interfere with room traffic,
has adequate ventilation, and offers an accessible pathway for
Power Vent installation.
Basic Operation:
The gas control components of this fireplace are located in the
bottom of the firebox below the burner system. All models are
supplied with a Honeywell smart valve gas control and do NOT
have a variable flame control. A differential pressure switch
is located at the bottom of the firebox monitors airflow and
controls the gas valve. A thermal switch located on the top of
the firebox acts as a secondary safety system and shuts down
the fireplace in the event that normal operating temperatures
exceeded. These components communicate with the electrical
control panel through a six conductor cable supplied with the
fireplace.
To operate the fireplace, Montigo supplies 20' of low voltage
wire from the electrical control panel. Connect the two wire
harnesses to a standard single pole ON/OFF switch to the
location of your choice. You may extend these wires up to 100'
in length with a wire of equal quality.
This fireplace is equipped with lights which need to be wired
through a wall switch or dimmer circuit as shown in the
schematic.
ON/OFF control of this appliance can also be performed using
an optional remote control available from your Montigo dealer.
RP620 Power Vent Indoor Gas Fireplace
Page 7