Installation - Montigo RP620 Installation & Maintenance Manual

RP620 Power Vent Indoor Gas Fireplace
Introduction to the RP-Series Fireplace:
The complete system will require a firebox, a power vent
termination, an electrical control panel, and a vent system.
There are 3 different power vent terminations available
depending on your installation requirements. Each power vent
requires a control cable to be installed between the power vent
and the control panel. Review the installation sequence on
page 7 for general information on preparing for a successful
installation of your fireplace. The RP-Series fireplace is not
intended to be used as a primary heat source and should
not be connected and operated with a thermostat switch.
PVHEX58-300
Horizontal Power Vent
PVHFL58-300
Horizontal Power Vent
Flush / Louvered
RP620
Fireplace
Figure 2.
RP620* major components
Page 6
Introduction

Installation

PVVEX58-300
Vertical Power Vent
Light Wiring
(not supplied)
Steel Stud Kit
(supplied)
Non-Combustible
Wall Board Facing
(supplied)
Appropriate Montigo Venting
Components 5" x 8"
Power Vent Control Cable
(Not supplied. Order required
length from your Montigo Dealer)
Fireplace Light
Switch or Dimmer
(not supplied)
Control Panel
Wall Switch
On/Off
(not supplied)
20' low voltage wire supplied
115 VAC 60 Hz
supply from
distribution panel
Control Box Cable
30' supplied standard
XG0777 - 100113.1