AMT Datasouth Fastmark M4 Series User Manual page 46

Item Description
Use this item to setup printing darkness. The available
Density setting is from 0 to 30, and the step is 1. You may need
to adjust your density based on selected media.
Use this item to setup print speed. The each increase or
Print Speed
decrease is 1 ips. Available setting is from 1 to 6.
This item is used to fine tune media stop location.
Tear Off
Available setting value is "+" or "-" from "0" to "9".
Printer Mode
Tear Off Mode
Print Mode
Peeler Mode
The above options are used to set media present modes.
This item is used to set print width. The available value is
Print Width
from "0" to "9".
This feature is used to print current printer available fonts
list to the label. The fonts stored in the printer's DRAM,
List Fonts
Flash or optional memory card.
This feature is used to print current printer available
images list to the label. The images stored in the printer's
List Images
DRAM, Flash or optional memory card.
This feature is used to print current printer available
List Formats formats list to the label. The formats stored in the
printer's DRAM, Flash or optional memory card.
This feature is used to print current printer configuration
List Setup
to the label.
Control
This feature is used to set control prefix character.
Prefix
Format
This feature is used to set format prefix character.
Prefix
Delimiter
This feature is used to set delimiter character.
Character
Description
Next label top of form is aligned to the
print head burn line location.
Enable the label peel off mode.
Continued on next page
~ 46 ~
Default
16
2
+000
Tear Off
812
N/A
N/A
N/A
N/A
N/A
N/A
N/A