Table of Contents
Advertisement
This item is used to set the print mode. There are 3 modes as below,
Print mode
This item is used to fine tune media stop location. Available setting
Offset
value is from "+" to "-" or "0" to "9".
Shift X
This
from "+" to "-" or "0" to "9".
Shift Y
Reference X
This
Reference Y
and vertically.
Code page
Use this item to set the code page of international character set.
Country
Use this option to set the country code.
NOTE:
If printing from enclosed software/driver, the
software/driver will send out the commands, which
will overwrite the settings set from the panel.
Printer
Description
Mode
Next label top of form is aligned to the print
None
head burn line location. (Tear Off Mode)
Once image is printed completely, label
Batch Mode
gap/black mark will be fed to the tear plate
location for tear away.
Peeler Mode
Enable the label peel off mode.
item
is used to fine tune print position.
item
is used to set the origin of printer coordinate system horizontally
Available setting value is from "0" to "9".
~ 44 ~
Available setting value is
Batch
Mode
+000
+000
+000
000
000
850
001
Advertisement
Table of Contents
